What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 11:15

There are two important concepts here.
At one ohm, the resistor has a maximum of 1 watt power.
These are simplified answers to the original question, and does not change anything I wrote above.
eight
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
A circuit breaker is similar, but is resettable.
A fuse is a non-resetable over current circuit protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The other is “what does a “fuse” do?”
[image of Common-mode choke]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Eight Centers Lions Could Sign to Replace Frank Ragnow - Sports Illustrated
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
What is lightning?
but I think this circuit , shows a few more pieces.
What are the best ways to treat seasonal allergies?
Edit 2024–10.
The MOV will conduct when the voltage exceeds 50% of line voltage.
The bolt then partially travels down the line to your home.
Panthers' winning formula goes missing in Stanley Cup Final Game 1 loss to Oilers - NHL.com
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
Why are Trump supporters so incredibly stupid?
But it can get overloaded, and no longer works.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What does it mean to live "the 'underconsumption' life"?
It also is a device that limits the change in current flow.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Upvotes:
This 1 Kitchen Tool Can Help You Cut Back On Oil & Calories, Dietitian Says - TODAY.com
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But… the neutral is now “floating” because of the 1 ohm resistance.
There are three different concepts here that are getting confused.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What is your analysis of Walter White from Breaking Bad?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
(Dc diagram shown, AC is similar).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
IBD 50's Hims & Hers Erases Its 19% Acquisition-Tied Sprint - Investor's Business Daily
but this device (an Inductor) … impedes the rapid changes in the current.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
It has been said that people with ADHD can often hyperfocus. Can that be an advantage?
The third is lightning and “how it gets conducted into a home.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What should I expect after a BBL surgery?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
I post the exact comment here.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, what happens?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
what exactly is a ‘surge’ protector?
Here is a simplified AC power diagram.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is where the MOV conducts again, and dissipated the energy.
Because the load is inductive, the current lags the voltage.(by a bit).
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–14 [Omar Gharbi Omar Gharbi ]
It seems Mohan does not understand the difference between a comment and an Answer.
He then asserts :
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is 'the assistant's answer'
He then describes the function of a fuse.
One is “what exactly is in a ‘surge protector’ ? ”
An AC voltage/ current source, and an ac inductive load.
First Sentence:
[old diagram got deleted by accident]
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–16 [ OO OLAOYE OYEBODE ]
At least they know the answer if they wanted it.
a photo is worth a thousand words.
2024–10–10[John johnson John Johnson ]
What does a fuse do?
In schematic diagrams this is the symbol for a fuse:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This device then solves the entire problem.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Barnstars:
For this case there are devices called Metal oxide varistors (MOV).
He then describes Rainy Season and Lightning.
This one hit behind the barn.